When I connect to ASA from L2 S/W using IPSEC Tunnel .
When I connect to ASA from L2 Switch using IP sec Tunnel, I invocked the cli command, the session hang up, and then I can't L2 Switch , If I want to connect to L2 Switch again, I must reload L2 Switch.
Is this a ASA Security function?
I attached the configuration my customer site. the public ip was deleted due to security issue.
Re: When I connect to ASA from L2 S/W using IPSEC Tunnel .
To view the threat detection configuration, use the show running-config threat-detection command in privileged EXEC mode.
show running-config [all] threat-detection
option : all -- (Optional) Shows all threat detection commands, including the commands you have not changed from the default. For example, you can view the default rate limits for the threat-detection basic-threat command.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...