Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Why can't I search for MAC templates in WCS?

OK, here is the deal:

When searching to see if a particular MAC address security template has been applied to our controllers, I need to look through each page of the "MAC Filter Templates" manually, which is a royal PIA. To make things even worse, the newer version of WCS software (4.0.96.0) adds new "MAC Filter Templates" to the end of the MAC filter list instead of putting them in order. So what had been a tedious search now has become impossible.

Is there another way to see if a mac filter has been applied to a controller instead of paging through each one by one? Am I missing something here or is this a really bad design?

1 REPLY
Community Member

Re: Why can't I search for MAC templates in WCS?

MAC filters is configured through WCS as a template, then pushed out to the controllers managed by WCS

152
Views
0
Helpful
1
Replies
CreatePlease to create content