cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2625
Views
15
Helpful
21
Replies

Wi-Fi WPA-PSK TKIP AUTH_FAILED Palm Treo 700w

wchaffin
Level 1
Level 1

I'm not able to get a Wi-Fi card to connect to a cisco AP1200 when everything is setup for WPA-PSK/TKIP. The Treo 700 sets on "connecting" and the AP generates an auth_failed error.

I know PSK is right on the AP and treo. This is not a new wireless deployment. Has anyone seen this problem?

Thanks, Bill, CCIE/MCSE

Authentication method:

WPA-PSK: The 64-character pre-shared key is entered.

Data Encryption method:

TKIP is turned on.

The Treo SSID shows "Connecting".....

The AT state shows "Association processing"

The AP generates a "Debugging Station xxxx.xxxx.xxxx Authentication failed" about every 5 seconds.

(where xxxx.xxxx.xxxx is the real MAC)

debug aaa authentication

000944: Feb 1 10:28:25.947 UTC: %DOT11-7-AUTH_FAILED: Station xxxx.xxxx.xxxx Authentication failed

000945: Feb 1 10:28:27.880 UTC: AAA/BIND(000004F0): Bind i/f

000946: Feb 1 10:28:29.612 UTC: AAA/BIND(000004F1): Bind i/f

000947: Feb 1 10:28:31.483 UTC: AAA/BIND(000004F2): Bind i/f

000948: Feb 1 10:28:31.784 UTC: %DOT11-7-AUTH_FAILED: Station xxxx.xxxx.xxxx Authentication failed

000949: Feb 1 10:28:33.217 UTC: AAA/BIND(000004F3): Bind i/f

000950: Feb 1 10:28:34.946 UTC: AAA/BIND(000004F4): Bind i/f

000951: Feb 1 10:28:36.771 UTC: AAA/BIND(000004F5): Bind i/f

21 Replies 21

Sounds good. I will give it a try first thing on Tuesday morning (PST) and let you know my results. Thank you so much for responding!

I started this thread with the same problem:

Palm Treo 700w WPA-PSK Connecting....

I too will try today and advise.

Chipset?? on the treo?

My APs are two models:

AIR-AP1242AG-A-K9 12.3(7)JA2

AIR-AP1231G-A-K9 12.3(7)JA2

Many thanks!

I have just tried the disabling of WMM and the client associates straight away with no other issue

I'm using a Ipaq HX4700 associated to a 1200

Many thanks for this, it has just solved my problem

Glad to here it solved your problem. You wouldn’t believe the amount of time I spent on this one….. Please rate the post.

I had similar problem. My PDA couldn't connect to Aironet 1200.

I had to change configuration AP:

conf t

dot11 wpa handshake timeout 500

interface Dot11Radio0

no dot11 extension aironet

end

Now all work fine.

#sh dot11 as 0009.2d82.e4b9

...

Key Mgmt type : WPA PSK Encryption : TKIP

Current Rate : 11.0 Capability : ShortHdr

Supported Rates : 1.0 2.0 5.5 11.0

Signal Strength : -39 dBm Connected for : 52213 seconds

...

B-I-N-G-O

conf t

dot11 wpa handshake timeout 500

interface Dot11Radio0

no dot11 extension aironet

end

thanks my firend.

This did solve my problem! Thank you so much. Since you were the first one to respond with the solution, I will rate your post.

Review Cisco Networking products for a $25 gift card