AIR-WLC4402-25-K9 running 188.8.131.52 and I setup guest internet-only access which worked for 2 days. I change both the "User Idle Timeout (seconds)" and "Enable Session Timeout " to 10hours (36000) as guest was complaining he had to re-authenticate again. Anyways, guest was still able to pickup ip address and logs show that life "appears" fine but he had not internet guest access. He had a Windows7 box...anyways, before I can finish troubleshooting, he had to leave....My question is if there is any issues with Windows 7 that others had a problem...or is it the timers I tweaked - or both?
Thu Apr 8 15:19:06 2010
User joe logged in. Client MAC:00:12:f0:99:71:ce, Client IP:192.168.55.110, AP MAC:00:00:00:00:00:00, AP Name:N/A
Thu Apr 8 15:09:28 2010
User joe logged in. Client MAC:00:12:f0:99:71:ce, Client IP:192.168.55.107, AP MAC:00:00:00:00:00:00, AP Name:N/A
To work around this Microsoft describe how to use Group Policy to turn off this feature. As Group Policy cannot be applied to guest PCs, allowing the traffic specifically related to this feature through the WLAN controller and firewall will stop the PC issues you have seen but still retain the requirement for users to accept the splash screen before having access to the internet.
This can be achieved by creating a Pre-authentication ACL on the Guest WLAN interface:-
Configure a preauthentication ACL on the WLAN to allow wireless clients to allow:-
1.Permit DNS resolution (UDP/53) to 184.108.40.206
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...