I have a problem with Wireless Control System (WCS v7) WCS-STANDARD-K9 and installed with WCS-PLUS-100 (installed two licenses) so total licensed installed is for 200 Acesspoint's in WCS. I have 149 AP's connected to WCS and its shows error " System is in voilation of license. The number of APs (149) registered is greater than licensed (0). Please go to the license center under the Administation Menu to add additional WCS licenses.
If you go to the license center in WCS, do you see a total of 200 AP support. You need to make sure you have a base license before you add additional plus license. I had an issue before, where I added a whole bunch of plus license after I installed a 250 base. I had 400+ APs and ran into the same issue but I had 250 base. Well I forgot to add the other 250 base so I had to remove all the plus license before I could add the other 250 base. Then I had to add all those plus license after that. The license center will tell you exactly how many APs it will support. From what you posted, it looks like you have 0.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...