Has anyone sucessfully implemented Dynamic VLAN assigment. I have not been sucessful. I am using at IOS Based 1200 with ACS 3.2. I am using PEAP as the authentication mechanism and I have tried both SSID assignment and VLAN assignment VIA RADIUS and neither will work. With SSID assignment I get caught in an authenticate/deauthenticate loop. With VLAN assignment it seems like the AP is just ignoring the keys and leaves me in the SSID/VLAN that I initially associate with. I have looked at the Wireless Virtual LAN Deployment guide and cannot find anything different than I am already doing.
WOW..I have been trying to get VLANs to work for the past three days. Thank you. I am glad I found this forum. I will try the config you mentioned and let you know how it worked. But I need to know how did you release the IP and config from the interface BVI1 and make it no ip address no ip route-cache. Here is my example using IOS 12.2 on a AP1200
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...