How can I configure the WLC to recognize a WLAN (subnet)across a WAN link? If I create a WVLAN interface on the WLC for the remote subnet, the WVLAN is local to the WLC. I thought I needed to do some sort of config using REAP, but when I select REAP under AP mode on the WLC, I get an error: REAP mode not supported on this AP. I am using AP model AIR-LAP1131AG-A-K9. Lost! Thank You!
The 1131 does not support REAP at this time. Have a look at the following;
Here is an excerpt from "Ask the expert" with Darren Douglas from Cisco;
"For local bridging of traffic, there is a function known as "Remote Edge AP" (REAP), which is currently supported on the AP1030 which permits local bridging of traffic. The REAP also maintains existing 802.11 sessions upon controller outage, but does not accept new 802.11 sessions. Stay tuned for enhancements to this REAP functionality with upcoming software releases."
From this "Ask the Expert" thread from April of this year;
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...