In order to get 802.11n speeds you have to use either Open or WPA2/AES as L2 security. In addition to that you have to enable WMM under WLAN->QoS section. It can be set either "Allow" or "Required"
Keep in mind, if you set it to "Required" then non-WMM capable client cannot join your WLAN. So in your environment if you have mixed client then better to leave that option as default which is "Allow"
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...