Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Wireless - show dot11 statistics client-traffic

Below is the output from the above command:

1-001d.e049.f5a7 pak in 25 bytes in 3272 pak out 8 bytes out 1364
      dup 0 decrpyt err 0 mic mismatch 0 mic miss 0
      tx retries 0 data retries 0 rts retries 0
      signal strength 72 signal quality 27

But I am unable to find any documentation of the signal strength and signal quality?

Does anyone have a chart or docs as to what the figures mean? is it out of 100 and 100 been best etc?

Many Thanks

1 REPLY
Hall of Fame Super Gold

Re: Wireless - show dot11 statistics client-traffic

You want the RSSI (Radio Signal Strength Indicator) and the SNR (Signal-to-Noise Ratio) of a particular client?

You have to run one or two commands then.  The first one is "sh dot11 s".  This will show you the wireless MAC address of a client.  Copy-n-Paste the MAC address of your choice and use the command "sh dot11 s ".

Does this answer your question?

Please don't forget to rate useful posts.  Thanks.

2130
Views
0
Helpful
1
Replies
CreatePlease to create content