The easiest way to do this is on the client side use the Microsoft client (suplicant) and use either PEAP or EAP-TLS. If you are using IAS, configure the wireless policy for a wireless users group and add the users as well as the computers to the group. When the users log in, they will be authenticated as that user. When they log off it reauthenticates as the PC. This allows group policy, remote desktop etc. The only problem you can have is with remote desktop and EAP-TLS. If you do a remote desktop connection to a PC that is authenticated with EAP-TLS it will drop your connection as the RDP client does not pass your cert info in the remote desktop session.
You can potentially do this with a third party supplicant, but they are usually pretty cludgy.
Ok, I was thinking that you where using IAS, Microsoft's RADIUS Server. When using IAS you specify a group that has WiFi access. I now assume that you are using ACS, or some other group. You may have to do a group matching (Check with the person who manages the RADIUS server) to get it to allow the computer accounts to authenticate. This does work with Cisco ACS, and should work with any RADIUS.
If you are doing group matching for WiFi authentication you want to put the computers and the users in the same Windows Group for WiFi authentication as the PC and the user.
The authenticate as a computer is on the Wireless Zero config on the client. This is the default setting, so this should be enabled already.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...