I am having a problem with the WISM blade blocking UDP traffic on port 6001. This is for a Sentinel Hardware Key. The software sends out a UDP request but it appears that the controller just drops it. I have tried an explicit permit ACL on this network for all UDP traffic. This did not work either. This software work fine on the wire. Anyone else seen this?
All layer two broadcasts (FF:FF:FF:FF:FF:FF) are stopped at the WISM. This is a function of the controller. I found a white paper from Cisco stating this. The hardware key I was trying to use, utilized a layer two broadcast and it was stopped at the controller. There were no ACL's present when I started testing. I even tried it with an allow all ACL just to make sure.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...