Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WiSM installation problems

I'm trying to install the WiSM in a 6509-E switch. There will be no connection between Sup720-3B and WisM. The Service Port is not getting ip address bij DHCP scope on 6509 switch.

wism service-vlan 51

wism module 8 controller 1 allowed-vlan 50,51,64,66,68,70,72,74,76,78,80,82,84

wism module 8 controller 1 allowed-vlan 86,88,90,92,94,96,98,100,102,128,130

wism module 8 controller 1 allowed-vlan 132,144

wism module 8 controller 2 allowed-vlan 50,51,64,66,68,70,72,74,76,78,80,82,84

wism module 8 controller 2 allowed-vlan 86,88,90,92,94,96,98,100,102,128,130

wism module 8 controller 2 allowed-vlan 132,144

wism module 8 controller 1 native-vlan 51

I configured a layer 2 and layer 3 VLAN 51 and assigned ip address to the SVI..

Service Vlan : 51, Service IP Subnet : 10.200.51.1/255.255.255.248

WLAN

Slot Controller Service IP Management IP SW Version Status

----+-----------+----------------+----------------+-----------+---------------

8 1 0.0.0.0 0.0.0.0 Service Port Up

8 2 0.0.0.0 0.0.0.0 Service Port Up

Also Session slot 8 pro 1 is not possible..

What can be wrong ?

Regards

Remco

2 REPLIES

Re: WiSM installation problems

have you enabled dhcp on the 6509?

service dhcp

Session slot 9 pro 1 will not be possible until you can assign it an ip address

New Member

Re: WiSM installation problems

Service DHCP is enabled (by default)...

249
Views
0
Helpful
2
Replies