Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WiSM Module powered off

I am using a Fan Module 1 on a 6509 chassis and it is giving me an error of insufficient cooling, is there a way around it or do I need Fan Blade 2??

Also how can turn on the WiSM Module?

7 REPLIES

Re: WiSM Module powered off

You can issue an hw-module boot or hw-module reset

If you need additionnal get it, you should not try to work around such need.

Community Member

Re: WiSM Module powered off

I tried that command but this is what I am getting;

Router#hw-module module 6 reset

Proceed with reload of module?[confirm]

% module 6 is operationally off (insuff cooling capacity)

any ideas?

Community Member

Re: WiSM Module powered off

What version of Code are you running? Also what SUP module is in the chassis?

Re: WiSM Module powered off

you need to add a fan in your cat6k chassis in the fan slot.

Hall of Fame Super Gold

Re: WiSM Module powered off

Did you just newly-insert the WiSM? By default, power to the module is turned off until enabled by using the command

"power enable module ".

Hope this helps.

Community Member

Re: WiSM Module powered off

I tried that command and nothing happened. I am thinking I do need fan blade 2 to get this going...

on the side not what is the command to combine the power supply output instead of the redundant mode..?

Hall of Fame Super Gold

Re: WiSM Module powered off

If you look at your chassis now, do you see a green status lamp of the WiSM? If not, then it's not getting power. What is the result if you do a "show module"?

sh power status power-supply <1 or 2>

2108
Views
0
Helpful
7
Replies
CreatePlease to create content