Just starting to test this out and configure everything. ACS is setup with the controllers and my test user. Using LEAP (802.1x). From the controller I can ping my ACS box and ping my access point. From the vlan that the access point is configured on I can ping to my ACS box. When I go to authenticate it fails. Check the failed attempts in ACS and there is no entry, which makes me think I'm not even hitting the box. Was thinking of putting a sniffer behind the ACS box, but will I see anything? Or will it be all encrypted? If there is anything I need to post here to get more help let me know. Thanks in advance.
Also, when I take off the security. I connect and can ping everywhere with no problems. One more thing that has me a bit confused is that with the controller set to broadcast the SSID in the WLAN it won't broadcast.... atleast not that I'm seeing. Thanks again.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...