Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WiSM Trunk Issue

Anyone know how to reset the WiSM to factory defaults? Troubleshooting FAQ suggests resetting WiSM and entering "recover-config" at the username prompt, but that did not work. I made a change to one of the gig ports and it brought down the port-channel that's dynamically configured during initial configuration. Since I can't restore the port-channel, I need to start over...

3 REPLIES
Hall of Fame Super Silver

Re: WiSM Trunk Issue

Reseting the WLC's in the WiSM will not restore your port-channel configuration. You need to re-configure your trunk port and the port-channel on the switch and you should be okay. The recover-config at the username will just clear the wlc config. Take a look at this doc... it might help you with the initial switch configuration.

http://www.cisco.com/en/US/products/hw/modules/ps2706/products_tech_note09186a00808330a9.shtml

-Scott
*** Please rate helpful posts ***
New Member

Re: WiSM Trunk Issue

That's how I configured initially. I have reconfigured the port-channels to the original configuration, but the high-order port-channel (that gets dynamically created when the initial port-channel was configured) can't be configured since the port-channel command only allows 1-256 and the Wism port-channel are above that.

The physical port channels are up/up, but the dynamic high-order port-channel status remains SD.

Re: WiSM Trunk Issue

Depending on which version of IOS you are running, it should re-create the channels on its own.

if you back out the wism config commands on the switch, it should create the interface/channels for you.

no wism service-vlan xxx

no wism module x controller 1 native vlan xx

no wism module x controller 1 allowed vlans xx,xx

do for controller 2 as well

and then re-add them.

afterwards, do the following:

sho wism status

sh wism module x controller 1 status

sh ether-channel xxx (what the wism/720 created) summary

358
Views
0
Helpful
3
Replies