Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Wism1 - AP Operational Status Downloading

Hi,

one of my AP (AIR-LAP1131G-E-K9) has stuck on downloading. I try to restart it few times but he always stop at operational status downloading.

Other AP (same model and 1142) are working ok.

I did also try

Perform a primary image pre-download on this  AP and Perform a interchange of both the images on this AP but also no result.

Any advice?

THX,

Ivan

3 REPLIES
Bronze

Re: Wism1 - AP Operational Status Downloading

better get ap console log for further analysis

Sent from Cisco Technical Support iPad App

Community Member

Re: Wism1 - AP Operational Status Downloading

Problem solved, when I connected AP in my office it start working

Community Member

Re: Wism1 - AP Operational Status Downloading

Please check the software version of the WISM-1 So that you can understand that the model is supported to it or not, because if one of your AP is working with it is means the configuration is ok and WISM is working fine .

Q. What access points are supported by the Cisco WiSM?

A. The Cisco WiSM supports Cisco Aironet access points running Lightweight Access Point Protocol (LWAPP) only. This includes any enabled Cisco Aironet Series 1000 (1010,1020, 1050), Series 1100 (1120, 1130, 1140), Series 1200 (1230, 1240, 1250), and Series 1520 (1522, 1524) access points.

338
Views
0
Helpful
3
Replies
CreatePlease to create content