Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 4402 and 1231 - SSID not broadcasting

We have a WLC 4402 running 7.0.98.0 with several 1131s, 1300s, and 1 1231. Since i upgraded from 6 ro 7.0.98.0 the SSIDs aren't broadcasting on the 1231. I have an AP Group with two WLANS and the AP joined to it but the SSIDs aren't broadcasting. Any suggestions?

7 REPLIES
Hall of Fame Super Gold

Re: WLC 4402 and 1231 - SSID not broadcasting

What switch is the 1230 connected to?  How is it powered, PoE, Injector or power brick/adaptor?

New Member

Re: WLC 4402 and 1231 - SSID not broadcasting

2960 and external power. the AP is joined and talking to the WLC just not broadcasting the 2 configured SSIDs in the AP Group. This only happened after the upgrade.

New Member

Re: WLC 4402 and 1231 - SSID not broadcasting

sorry to bump...any suggestions?

Hall of Fame Super Gold

Re: WLC 4402 and 1231 - SSID not broadcasting

Dunno.  Never seen this before.  If you take the APs out of the AP Group what happens?  Maybe all you need to do is to "rip" out the AP Groups and create them again.

Re: WLC 4402 and 1231 - SSID not broadcasting

I assume your clients are still connecting? Have you set the correct WLAN-id?

Also, from what I recall the default group, handles up to 16 broadcasts SSID.

What happens if you enter: config network broadcast enable ?

New Member

Re: WLC 4402 and 1231 - SSID not broadcasting

Hello Al I was able to reply this issue, I have the next scenario:

1 WLC 4402 fw ver 7.0.98.0 for 50 ap's that are managing just 23 aironet 1242,  22 of the 23 ap's are connected to a Catalyst 3560 however the ap' that is alone is connected by a power injector to another sw vendor. This ap is not able to enable the interface dot11 0 corresponding to the 802.11 b/g radio event when i configured the ap to support a power injector with the mac address of the switch port that is connected.

I think it could be a firmware issue if  it worked with the older fimrware version of the wlc

Did it work properly with the older firmware version?

New Member

Re: WLC 4402 and 1231 - SSID not broadcasting

i forgot to add al the Catalyst switches have POE

2436
Views
0
Helpful
7
Replies