Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 4402 lost APS

hi

i executed the cmd reset system on the WLC.now i ahve lost all my 19 APS that were joined to the controller.How do i get the APs back to the controller.

1 REPLY
Silver

Re: WLC 4402 lost APS

You might try turning on Master Controller Mode on the WLC.

You will want to make sure that any other controllers (if you have any others) do NOT have master controller mode enabled.

Also, in certain situations, I have performed a SHUTDOWN and NOSHUTDOWN on the ports feeding the APs to give them a kick in the pants.

I hope this helps,

John

139
Views
0
Helpful
1
Replies