Just saw that WLC 18.104.22.168 release notes were posted today.
Looks like some very important updates. Can't wait for the software to go live.
rel notes state the following:
"Access Point Changes
â¢Cisco Aironet 1000 Series Access Points-The 1000 series access points are not supported for use with controller software release 22.214.171.124. "
I wonder if they are referring to the airspace series or aironet 1000 series, I know it sounds obvious, but I do not recall any aironet lwapp capable 1000 series radios and there have been typos on cisco.com from time to time.
I have a handful of 1020 series left and do not want to move forward until I find out the answer
OK, here is the answer I was looking for.
Cisco now refers to the airspace radios as aironet. very confusing for us who dealt with both in the past.
So, yes, the 1020 radios I have will no longer work with 5.x, that also holds true for any vxworks based lwapp radios such as the 1510 as well.
I knew there was a reason I bought some extra 1252s....
I got it and I am having issues with the bootloader version updating after load the ER file. Anyone else having the same issue?
Did you remember to turn off the A radios and b/g radios as well as any active SSIDs? Also remember under the new codes that some symbols are not supported in the SSID such as @.