I have 240 cisco ap's throughout my campus. Most are located in a main building. I have been asked to enable dynamic channel and power assignment. I really don't want to unleash the change on the entire campus at one time. Can anybody advise me how to do small sections at a time? I have looked at ap groups and I don't really see how that would help me. I am using a cisco 5508 controller. Code is 220.127.116.11. TIA
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...