Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

WLC 5508 and Client IP addresses

we have installed our first 5508 in a small remote office.  I setup a DHCP range on the 5508 to give the AP's a IP address.  After that I changed the AP's to have static IP address.  I wish for the wireless clients to use our DHCP servers here at the home office, so I shut down the DHCP service on the 5508.  Now the Clients will not get an IP address.  So now I re-enable the scope and the clients get an IP address.  How do I configure the 5508 so that the wireless clients will get an IP address from our DHCP servers and not the 5508?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: WLC 5508 and Client IP addresses

Go to WLAN > click the SSID of your choice > Advanced tab > click on "DHCP Server" and enter the DHCP Server.

3 REPLIES
Hall of Fame Super Blue

Re: WLC 5508 and Client IP addresses

Go to WLAN > click the SSID of your choice > Advanced tab > click on "DHCP Server" and enter the DHCP Server.

Community Member

Re: WLC 5508 and Client IP addresses

thanks,

that did it.

Hall of Fame Super Blue

Re: WLC 5508 and Client IP addresses

Thanks for the ratings.

813
Views
0
Helpful
3
Replies
CreatePlease to create content