Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WLC 5760 operation state down

Hi all.

I have 2 WLC 5760 (version 3.6) in stack and 20 APs .

All APs registered on WLC but  operation state in both radio is DOWN .

APs connected on different switches.


What can it be ?

 

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
VIP Purple

Yes, if it is disabled due to

Yes, if it is disabled due to PoE then you need to correct that. If AP model are newer one (2700/3700) then try to power them from a POE+ switch

If you have a test AP then you can watch the console output while powering/booting. That will tells if AP radio goes down with reason.

 

HTH

Rasika

**** Pls rate all useful responses ****

4 REPLIES
VIP Purple

HiHave you configured the

Hi

Have you configured the correct country code on your 5760 ?  If you check "show wireless country configured" & see the correct configuration done. 

HTH

Rasika

**** Pls rate all useful responses ****

 

 

New Member

Hi Rasika.County code on wlc

Hi Rasika.

County code on wlc same as on APs

wlc-1#show wireless country configured

 Configured Country.............................: RU  - Russian Federation
 Configured Country Codes
        RU  - Russian Federation : 802.11a Indoor,Outdoor/ 802.11b / 802.11g

wlc-1#show ap status
AP Name                             Status     Mode              Country
-------------------------------------------------------------------------
APb838.61f3.2ed9                    Enabled    Local             RU
APb838.61f3.2f1b                    Enabled    Local             RU
AP18e7.28bd.4ef1                    Enabled    Local             RU

I think problem in PoE , cause APs conect to old 6509 with CatOS, but output comand show port powerinline  show that all good and 15.4 W go to port.

 8/73  auto   on       15400   14607   13000             cisco+ieee  class 3  
 8/74  auto   on       15400   14607   13000             cisco+ieee  class 4  
 8/75  auto   on       15400   14607   13000             cisco+ieee  class 3  
 8/76  auto   on       15400   14607   13000             cisco+ieee  class 3  
 8/77  auto   on       15400   14607   13000             cisco+ieee  class 3  

 

In the output "show tech"  from the ap a found this message

Radio disabled due to PoE

 

VIP Purple

Yes, if it is disabled due to

Yes, if it is disabled due to PoE then you need to correct that. If AP model are newer one (2700/3700) then try to power them from a POE+ switch

If you have a test AP then you can watch the console output while powering/booting. That will tells if AP radio goes down with reason.

 

HTH

Rasika

**** Pls rate all useful responses ****

New Member

I have 2 types of APs - 2600

I have 2 types of APs - 2600 and 3600.

Yes , just now connect APs to new 3850 switch and all APs go to UP .

Thanks for all .

234
Views
0
Helpful
4
Replies
CreatePlease to create content