Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLC 7.2.103.0 RADIUS Accounting

Hello,

I recently upgraded WiSM2 controllers to the 7.2 release and have found that quite a few Accounting Start and Stop packets arrive at the RADIUS server without the Framed-IP-Address.. We use it to login the wireless user into SCE so they are not prompted to login to use the Internet each time... So it's a very important piece of info for us.

Has anyone noticed that as well? Any workarounds or special builds available?

1 REPLY
New Member

Just in case anyone

Just in case anyone continuously searched for a similar problem to this - Cisco TAC recommended switching off IPv6 globally on the controller. This seemed to resolve the issue. 

 

I believe it has something to do with this:

 

http://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_usr_radatt/configuration/15-s/sec-usr-radatt-15-s-book/sec-rad-8-accss-req.html#GUID-B4D675F6-9B34-49FF-AB3E-FDAFC0FE43BB

 

Thanks

-N

866
Views
0
Helpful
1
Replies
CreatePlease login to create content