Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WLC + ACS - Full admin rights problem with rogue AP

Dear,

I have a Cisco ACS 4.2 (Windows) and a WLC 2106 5.1.

I would like that the Management User use the TACACS (with the ACS) to authenticate/authorize.

So I have follow the guide:

Cisco Unified Wireless Network TACACS+ Configuration (http://cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a0080851f7c.shtml)

Put in a users group : role1=ALL as describe in the guide.

The problem: With a user from the ACS, I want to contain a rogue AP and I receive a JavaScript Alert Box which display : Authorization Failed. No sufficent privileges.

In the management log:

---

*Aug 22 14:12:31.103: %WEB-3-USER_NOT_PRIVILEDGED: web.c:462 Form Submission Failed. The user doesn't have the right privileges.

*Aug 22 13:58:15.076: %EMWEB-1-LOGIN_FAILED: ews_auth.c:2092 Login failed. User:glemaireadm. Service-Type is not present or it doesn't allow READ/WRITE permission..

*Aug 22 13:56:46.078: %WEB-3-USER_NOT_PRIVILEDGED: web.c:462 Form Submission Failed. The user doesn't have the right privileges.

----

What I have missed in the configuration guide ? :o(

Thanks in advance,

2 REPLIES
Community Member

Re: WLC + ACS - Full admin rights problem with rogue AP

Hi,

I've got the very same issue with version 5.2.178.0. When trying to reclassify an AP, the log reports the following: *Jun 22 17:33:03.839: %WEB-3-USER_NOT_PRIVILEDGED: web.c:465 Form Submission Failed. The user doesn't have the right privileges.

However, if I login as the local admin user, works fine.

Was any solution discovered for this.

Regards,

Richard Wilkinson

Re: WLC + ACS - Full admin rights problem with rogue AP

It sounds like you're missing a permission. Presuming you copied them all out of WCS properly, then there's probably a fault in WCS in that there's no permission/name shown for that particular activity.

611
Views
0
Helpful
2
Replies
CreatePlease to create content