Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WLC Called station ID Issue

Hi All,

 

I have a problem with accounting from WLC. Sometimes we receive accounting of  users using called station ID = controller MAC address instead of the configured called station ID on controller “AP name : SSID” knowing that each user is connected form the same location . Please find below sample of accounting

Controller: WISM2 with image 7.4.100.0

 

User Name

NAS-IP

Framed IP address

Called Station ID

Calling Station ID

NAS ID

ACCTSTATUS TYPE

Input Octets

Output Octets

Acct session ID

Acct Session Time

Event Time Stamp

00127b38b496

10.94.70.2

84.233.48.235

90019-01:Etisalat_Hotspot

84.233.48.235

RMS-WLC1

Stop

821319

3166606

5320dd71/00:12:7b:38:b4:96/4007443

34200

Thu Mar 13 09:49:29 2014

00127b38b496

10.94.70.2

84.233.62.47

2c-54-2d-3a-31-20

84.233.62.47

RMS-WLC1

Stop

357141

7215694

5321b847/00:12:7b:38:b4:96/4057299

17445

Thu Mar 13 20:44:02 2014

 

Wait any feedback please .

 

Thanks

4 REPLIES
VIP Purple

If you still running 7.4.100

If you still running 7.4.100.0, then please upgrade to 7.4.121.0 & then check.

HTH

Rasika

**** Pls rate all useful responses ****

New Member

Thanks for your feedback.

Thanks for your feedback. But please if i face the problem after upgrade, can we expect where is the problem.
VIP Purple

The version I mentioned is

The version I mentioned is supported by Cisco TAC, so at least you can log a TAC case & find the root cause in worst case scenario.

If this is a buggy  behaviour of your current code 7.4.100.0 (lot of chances it may be), then you will not see this in later version.

It is not worth to do lots of troubleshooting, knowing that software code is deferred by Cisco. 

HTH

Rasika

*** Pls rate all useful responses ****

Bronze

Hi,Yes, it seems bugs in this

Hi,

Yes, it seems bugs in this code 7.4.100.0, its better you upgrade the latest version and then check, if problem exist then we will further rectify.. but most probably in will be fix in latest code.

130
Views
0
Helpful
4
Replies
CreatePlease to create content