Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Cisco Support Community site will be in read only mode on Dec14, 2017 from 12:01am PST to 11:30am for standard maintenance. Sorry for the inconvenience.

New Member

WLC - Client Traffic

Hi all;

We've approximately 80 ap in our network and we use 4404 as a controller. We also use WCS.

We need to see wireless client traffic reports over ap's like netflow . Is there any method to take these reports over wlc or wcs ?

Best regards

Thanks.

Everyone's tags (3)
1 ACCEPTED SOLUTION

Accepted Solutions

WLC - Client Traffic

The WLC doesn't have 'netflow' per-se, but there are reports that can be run, like the client throughput report.  Take a look at the link below to the WCS Reports section of the configuration guide.

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0reps.html#wp1190896

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
2 REPLIES

WLC - Client Traffic

The WLC doesn't have 'netflow' per-se, but there are reports that can be run, like the client throughput report.  Take a look at the link below to the WCS Reports section of the configuration guide.

http://www.cisco.com/en/US/docs/wireless/wcs/7.0/configuration/guide/7_0reps.html#wp1190896

Steve

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
New Member

WLC - Client Traffic

Thank you for your fast response..

I'm going to research...

1368
Views
0
Helpful
2
Replies
CreatePlease to create content