Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLC DHCP

I'm using the internal WLC DHCP to assign DHCP addresses to our APs. If you have more then one scope defined in the internal DHCP how it is determined which scope the APs use versus clients on a WLAN?

Ran into an issue last week where our APs started using addresses from the other scope and the wireless network went down. Seeing a design issue where the WLC interface and one of the WLAN are using the same VLAN. Thinking I need to separate the WLANs from the WLC AP Manager and Mangement interfaces.

Craig

3 REPLIES
Hall of Fame Super Silver

Re: WLC DHCP

You do need to seperate the AP's from the wireless user subnet especialy if you plan on using dhcp on the wlc. I always place the ap's on seperate subnets from any wired or wireless user subnet. I will place them in a management subnet if possible.

-Scott
*** Please rate helpful posts ***
New Member

Re: WLC DHCP

Thanks. If you use the WLC internal DHCP server. How does it know which interfaces to serve IP addresses on.

Hall of Fame Super Silver

Re: WLC DHCP

In the dynamic interface, you would put the management ip address as the primary dhcp. You can also specify the primary dhcp on the wlan ssid.

-Scott
*** Please rate helpful posts ***
325
Views
5
Helpful
3
Replies