Not sure if this the right forum, but i'm wondering if anyone can explain this.
I have a trunk from the wlc to my router with one switch in between.
The interface on the wlc and the 2821 both have an ip address and can ping each other. When a wireless client connects to the guest network they cannot access the internet unless the 3560 switch has an ip address set on the vlan that is trunked from the wlc to the router
The gateway for the clients is 10.7.200.1 which is the router. If i take the ip address off of the vlan interface on the 3560 the trunk is still there, but the clients on the guest network cannot get through. The gateway on the interface on the wlc is also set to 10.7.200.1
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...