Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

WLC+LAP+ACS4.0 achieving 802.1x PEAP and MAC address authentication ?

How to configure WLC + LAP + ACS4.0, achieving username and password authentication and MAC address at the same time

1 REPLY
Hall of Fame Super Silver

Re: WLC+LAP+ACS4.0 achieving 802.1x PEAP and MAC address authent

This might help with the PEAP:

http://www.cisco.com/en/US/products/sw/secursw/ps2086/products_configuration_example09186a00807917aa.shtml

MAC Authentication

Add a MAC Address to ACS

Complete these steps:

1. From the ACS main menu, click on the User Setup button.

2. In the User text box, enter the MAC address to add to the user database.

Note: The MAC address must be exactly as it is sent by the AP for both the username and the password. If authentication fails, check the failed attempts log to see how the MAC is being reported by the AP. Do not cut and paste the MAC address, as this can introduce phantom characters.

3. On the User Setup screen, enter the MAC address in the Secure-PAP password text box.

Note: The MAC address must be exactly as it is sent by the AP for both the username and the password. If authentication fails, check the failed attempts log to see how the MAC is being reported by the AP. Do not cut and paste the MAC address, as this can introduce phantom characters.

4. Check the Separate (CHAP/MS-CHAP) box.

5. Enter a password for CHAP/MS-CHAP (this password should be different from the MAC address).

6. Click Submit.

-Scott
*** Please rate helpful posts ***
310
Views
0
Helpful
1
Replies
CreatePlease to create content