Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WLC PSK

So I have a 4402 and I have configured the WPA to use a Hex PSK using 64-bit. I type in 64 1's for example and click apply. When I go back into the WLAN it is set as ACSII not HEX. Any ideas? Is this a security feature?

3 REPLIES
Bronze

Re: WLC PSK

This is normal behavior of the wlc

New Member

Re: WLC PSK

Hello,

Diro is correct in saying that this is a normal behaviour of the wlc. For further clarification you can have a look at the following doc:

http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a00807f42e9.shtml

WLC PSK

After you configure the key, you can not know what type of key (ASCII or HEX) is configured. It always shows "ASCII" on the GUI and on the CLI WLAN config it shows the security as PSK only. it does not state ASCII or HEX.

This is how the WLC behaves.

Regards,

Amjad

Rating useful replies is more useful than saying "Thank you"

Rating useful replies is more useful than saying "Thank you"
281
Views
0
Helpful
3
Replies
CreatePlease to create content