Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

WLC User erased

If i erased the privilege user in a wlc 4404 and i just have a user with read-only privileges how can I get more privileges or created a new user with write privileges?

  • Security and Network Management
1 ACCEPTED SOLUTION

Accepted Solutions

Re: WLC User erased

If you removed the user that had RW privileges from the WLC, you wither need to have a WCS setup so you can push a new Local Management User down to the WLC, or you would have had to have it setup to do TACACS, feature in 4.1 and better, and then you could get in and add a local account as well.

If you removed the RW user, and do not have the ability to either of the two above, then you need to console into the WLC, and issue Recover-Config after a clean boot, and start over.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered
3 REPLIES
Hall of Fame Super Red

Re: WLC User erased

Hi Alejandro,

I'm not sure if I am understanding this correctly, but maybe you could just add this user as a Lobby Ambassador with Read-Write privledges.

http://www.cisco.com/en/US/products/ps6366/products_configuration_guide_chapter09186a008082d6b0.html#wp1048412

Hope this helps!

Rob

"May your heart always be joyful And may your song always be sung May you stay forever young " - Dylan

Re: WLC User erased

If you removed the user that had RW privileges from the WLC, you wither need to have a WCS setup so you can push a new Local Management User down to the WLC, or you would have had to have it setup to do TACACS, feature in 4.1 and better, and then you could get in and add a local account as well.

If you removed the RW user, and do not have the ability to either of the two above, then you need to console into the WLC, and issue Recover-Config after a clean boot, and start over.

HTH, Steve ------------------------------------------------------------------------------------------------ Please remember to rate useful posts, and mark questions as answered

Re: WLC User erased

Thank u, I have a WCS.

124
Views
0
Helpful
3
Replies
This widget could not be displayed.