Hi Members, can you help me find a way for Configuring only One Controller completely and then synchronising the Other(s) with "One Click", not using the granular Configuration Templates? Regards, Michael
Re: WLC/WiSM Configuration Synchronisation with WCS
An easier way would be to upload the binary configuration file from controller 1 to WCS and then push it from WCS to controller 2. At that point, all you need to change (via console) is the IP address.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...