We have two Wism2 controllers running 7.3.10 and in the last 30 days they have both doubled the memory usage on the controllers. They went from 26% usage to 51% usage. Is there a way to figure out what may have caused this increase in memory usage and is there any concern? We have not had any major changes or additions to our controllers.
We have a 3550 appliance stuck at 7.3 right now. We just bought the virtual Mse license and are getting ready to move over to it. We have 7.4.121 ready for the Mse since it is compatible with the other pieces of our wireless network. Then we can upgrade prime, wlc, etc.
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...