Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WLC with remote H-REAP AP and Web Auth

Hi,

I'm currently configuring a WLC4402 with AP1130 in LWAPP. On the remote site, AP1130 are using H-REAP mode just to be sure we will not use the LWAPP tunnel to access the Internet. That part work fine.

After that, I want to use Web Authentication with a Radius Server and an Externnal Web authentication page. Radius is working fine and "Internal" Web page of the WLC works fine too. The problem I have is when I tried to forward the authentication to an External Web Page, it look like I'm stuck inside the LWAPP tunnel?!? I'm able to resolv Internet address because DNS is permit, but I didn't find a way to permit HTTP to a specific IP before the authentification is done.

Any idea?

Version of the WLC software: 5.0.148

1 REPLY
Silver

Re: WLC with remote H-REAP AP and Web Auth

debug lwapp events enable. This command provides information on the LWAPP events and errors that occur during the LWAPP discovery and join process for verification.

394
Views
0
Helpful
1
Replies
CreatePlease to create content