I have 45 access point Standalone in workgroup bridge
The device in back of 45 access point Standalone in workgroup bridge is a Stratix 8000 (Rockwell). They use multicat, UDP and common industrial protocol (CIP)
I have two questions:
I must to activate the multicast. How can i activate the multicast in my workbridge, lightweight access point and WLC
In the WLC, when i activate the multicast in controler menu, he ask me (enter the IP address of the multicast group in the Multicast Group Address field.) but i don't no which. (WLC management, Stratix, ...?)
My question is about the communication between lightweight and WLC. I would to reduce the time to discover the secondary WLC if the first one is shutdown.
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...