I am having an issue with my 4402. In the WLAN I have created there is a setting called Session Timeout. This by default is set to 1800 secs. This forces the clients to reauthenticate on the wireless every 30 minutes. I want to change this to 28000 secs. I have tried through both the Web and CLI. It seems to accept the change with no errors however will not take the change. I have even done this at CLI, saved the config and reset the system. Still at 1800. How do we get this changed?
Have a look at this thread, just a guess here but I don't think that this setting is the one causing the 30 minute timeout. My understanding was that this setting is actually in minutes (could be wrong),
I looked at the link provided. This is actaully where I am trying to set this Session Timeout. If trying to set in the web it will only take 300 - 860000. In the CLI it will accept a zero although not what I want to use. In either case it will not change from 1800. I have attached a screen shot
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...