WLSE 1.3 compatibility with AP1200

[trabon]

I am attempting to change a static WEP key on my AP1200's running v.12.01 T1. I am using WLSE 1.3 to setup the configuration template. The job fails with error code 'Device version appears to be a newer version that is not yet supported.' We currently have 83 APs running this firmware version. Are there older AP1200 firmware version that are supported by WLSE 1.3 or am I out of luck?

[rmushtaq]

Two options:

1) Upgrade to WLSE 2.0 from: http://www.cisco.com/cgi-bin/tablebuild.pl/wlan-sol-eng and this should fix the problem for good OR

2) If you still want to use 1.3, then the following workaround will let you push this Config Template.

a) in the Config Template->Finish, uncheck the 'Enable Version Checking' box and do not click on Validate button. Just hit Save to save the template.

b) In the Config Job->Finish, do not click on Validate, just hit the Save button to Save and run the job.