Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLSE 1130 Release 2.13 - Archive issue ERROR:limit reached

When I back up my configs I am now seeing this message against some devices. I have checked that I only have 580 devices and the limit is 2500 (ish). I have also set up smaller jobs below the 500 collection limit to cover that possibility, still the same on smaller jobs... Any clues??

WLSE 1130 Release 2.13 - Archive issue ERROR:limit reached

2 REPLIES
Cisco Employee

Re: WLSE 1130 Release 2.13 - Archive issue ERROR:limit reached

Hi Steve.

There typically isn't a limit to the number of devices in a archive job. In order to debug this scenario further, could you please enable the 'debug' mode for Archive module(as mentioned in the last part of this

message) and then try the following:

i) Try an archive job with a single device which is reporting error.

ii) If the above job succeeds increase the count of devices to multiples of

100(say 100, 200, etc.) in the job.

iii) Again, if the above job succeeds, please increase the count of devices

in the job to whatever level causes the issue and run the job again.

Once the jobs are finished, save the jobvm.log(Admin-->Appliance-->View Log

File) to desktop and upload it here, and I'll take a look.

Steps for enabling 'debug' for archive module:

----------------------------------------------

i) Login as 'admin' user

ii) Go to the URL: http://:1741/debug/logging.jsp

iii) Enable 'Debug' option for 'Archive' module and click 'Save'.

New Member

Re: WLSE 1130 Release 2.13 - Archive issue ERROR:limit reached

scheduling some jobs today will follow your advice thanks

121
Views
4
Helpful
2
Replies
CreatePlease login to create content