Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

WLSE 2.11 occasionally sends a P1 notification e-mail

For some AP 1200's, WLSE sends a "P1 notification... Device was not

reachable via SNMP" followed by a "OK notification ... Device was

reachable via SNMP" after a few minutes (between 1 and 5 minutes).

Current poll interval setting is 5 minutes and frequency is 1.

There are no issues with the AP (interfaces and line protocol are UP/UP).

Any advise on what could be causing this problem (and any recommended

troubleshooting/solution) is greatly appreciated.

Thanks in advance.

Ariel

1 REPLY
New Member

Re: WLSE 2.11 occasionally sends a P1 notification e-mail

I would try just performing a constant ping to an AP and see if you are dropping any packets...it is possible that at a polling cycle it is timing out and then 5 mins later it replies. Do the same to your WLSE device to make sure its own connections are good. I am assuming your WLSE is on the same subnet as your ap.

121
Views
0
Helpful
1
Replies
CreatePlease login to create content