Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

WLSE 2.12 - TKIP Replay is detected (cnt: 1)

Since upgrading my APs to 12.3(7)JA, I am now seeing this error message often in the WLSE 2.12: TKIP Replay is detected (cnt: 1). The troubleshooting guide says "The fault threshold set has been exceeded.

When this fault is cleared, the following message displays: There is no TKIP Replay detected"

I still don't understand what this error is telling me... can someone elaborate?

2 REPLIES
Blue

Re: WLSE 2.12 - TKIP Replay is detected (cnt: 1)

New Member

Re: WLSE 2.12 - TKIP Replay is detected (cnt: 1)

The Faults doc says that the "TKIP Replay is detected" message means:

"The fault threshold set has been exceeded.

When this fault is cleared, the following message displays: There is no TKIP Replay detected. "

But I still don't understand - what fault threshold is it talking about? What triggers this fault to occur?

381
Views
0
Helpful
2
Replies
CreatePlease to create content