I am having trouble getting the wlse to auto-discover an ap1100. I have followed the steps(at least think I have)necessary to get a ap that runs VxWorks to be discoverd
1. CDP enabled
2. SNMP RO and RW , that is also in the discovery credentials on the WLSE
3. User account has been setup - with RW priviledge
4. TFTP is not an option unless upgrading the device via web browser (real-time).
I have checked the switch that is the ap physically connects to. It has different snmp strings, but those are also entered into the wlse. There is an access-list that only permits certain ip addresses that snmp query the switch. The wlse ip address is permitted in this access list. Does anybody have any ideas. I have reviewed the WLSE User guide, but did not see specifics on the IOS based AP's. My wlse is running 1.3.1u
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...
I have created a Powershell script to automatically add a Wireless Guest User on Cisco WLCs. (tested on 2500 Series)
The script should be completely self explanatory.
Powershell SNMP Module (Install-Module -Name SNMP)
SNMP Write Access to...