Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLSE and SNMP trap generation

I've recently installed WLSE 1.3 and upgraded to 2.0. On both versions I'm not receiving snmp traps from the WLSE on my network management system.

Syslog is working a treat.

When viewing the ADMINISTRATION->Appliance->snmpd.log I get the following output:

Cannot find module (IP-MIB): At line 0 in (none)

Cannot find module (IF-MIB): At line 0 in (none)

Cannot find module (TCP-MIB): At line 0 in (none)

Cannot find module (UDP-MIB): At line 0 in (none)

Cannot find module (SNMPv2-MIB): At line 0 in (none)

Cannot find module (SNMPv2-SMI): At line 0 in (none)

Cannot find module (UCD-SNMP-MIB): At line 0 in (none)

Cannot find module (UCD-DEMO-MIB): At line 0 in (none)

Cannot find module (SNMP-VIEW-BASED-ACM-MIB): At line 0 in (none)

Cannot find module (SNMP-COMMUNITY-MIB): At line 0 in (none)

Cannot find module (UCD-DLMOD-MIB): At line 0 in (none)

Cannot find module (SNMP-FRAMEWORK-MIB): At line 0 in (none)

Cannot find module (SNMP-MPD-MIB): At line 0 in (none)

Cannot find module (SNMP-USER-BASED-SM-MIB): At line 0 in (none)

Cannot find module (SNMP-NOTIFICATION-MIB): At line 0 in (none)

Cannot find module (SNMP-TARGET-MIB): At line 0 in (none)

Cannot find module (SNMPv2-TM): At line 0 in (none)

UCD-SNMP version 4.2.3

This occurred on version 1.3 before I upgraded.

The WLSE is however interrogating AP's via SNMP with no problems.

Can somebody help?

1 REPLY
Blue

Re: WLSE and SNMP trap generation

WLSE supports only SNMP v2c traps. For example, Solaris 2.8-based NetView 7.1 receives and displays the SNMP v2c fault notification traps from WLSE. Windows-based NetView 7.1 supports only v1 traps and cannot receive and display any v2c traps from the WLSE. The following MIB defines the trap and the varbinds: CISCO-DEVICE-EXCEPTION-REPORTING-MIB.my. It can be downloaded from CCO and loaded into the trap receiver. Make sure that you have setup the trap receiver's credentials correctly in WLSE under Faults->Notification Settings

242
Views
0
Helpful
1
Replies
CreatePlease login to create content