Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

WLSE Assisted Configuration

Hi:

I am deploying an AP1240 infraestructure managed by WLSE. So, I have 3 AP's on a floor
So, executing RM Assisted Configuration, WLSE set up the following values:


Device               Channel    TxPower              Beacon
                                                                      Interval
ap-oc-ctc1-2      11             0.7mW CCK
                                           0.7mW OFDM      99 
ap-oc-ctc1-3       6              50mW CCK
                                           50mW OFDM       99 
ap-oc-unicom01 1               50mW CCK
                                            50mW OFDM      99 

The question is, what does it mean if ap-oc-ctc1-2 was setting with low power?
This floor has an extra AP which would have been removed from the Infraestructure if necessary?

Best Regards

Fernando Mendoza

269
Views
0
Helpful
0
Replies
CreatePlease to create content