Buy or Renew
Buy or Renew
Cisco Virtual Engineer generative AI bot now active in Wireless Discussion Forum. Learn more.
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
319
Views
0
Helpful
1
Replies

WLSE cannot connect to WDS-AP after AP IOS upgrade

jimbostan
Level 1
Level 1

‎11-09-2005 07:37 AM - edited ‎07-04-2021 11:19 AM

Hi,

I have 4 WDS-APs that were working fine with my WLSE. I use local radius on the APs for WLSE authentication. I just upgraded all 4 APs to 12.3(4)JA1 and now the WLSE cannot connect to them. I'm running wlse2.11FCS......any suggestions?

...thanks in advance......Jamie

Labels:
0 Helpful
1 Reply 1

jimbostan
Level 1
Level 1

‎11-10-2005 07:00 AM

Hi,

It's fixed now.....turns out that this is a bug in 12.3(4)JA1. The work-around is to (on the wds-ap) manually enter the IP address of the WLSE and the MAC of the wds-aps default-gateway using the 'arp' command.

...thx.......J

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card