Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

WLSE Device Specific Configurations

I get an error when trying to use the device specific configuration:

15:34:43 02/09/2006 Device: usedevicespecific(AP1210, 12.3(2)JA2, 00137f39c4c3)

---Error applying configuration.

Does anyone have this working?

3 REPLIES
Blue

Re: WLSE Device Specific Configurations

What do the Job Run Detail->Job Run Log show for this?

New Member

Re: WLSE Device Specific Configurations

Here is the complete job run log:

08:26:47 02/10/2006 Device: usedevicespecific.mathsciencec(AP1210, 12.3(2)JA2, 00137f39c4c3)

---Applying template( SSH-Setup-Version5 ) configuration to the device.

--------------------------------------------------------------------------------

08:26:47 02/10/2006 Device: usedevicespecific.mathsciencec(AP1210, 12.3(2)JA2, 00137f39c4c3)

---Device Specific Parameters for this device are : hostName = APD-D020, sysLocation = null, sysContact = null, radioa_channel = 0, radioa_power = 0.0, radiobg_channel = 0, radiob_power = 0.0, radiobg_power_cckm = 0.0, radiobg_power_ofdm = 0.0, customCommand = null.

--------------------------------------------------------------------------------

08:38:18 02/10/2006 Device: usedevicespecific.mathsciencec(AP1210, 12.3(2)JA2, 00137f39c4c3)

---Error applying configuration.

--------------------------------------------------------------------------------

It looks like it runs the first part ok. This actually changes the hostname. Then it tries to send the device specific config, but can't find it because the host name has changed.

I can see the device under group management with the new host name.

I know I can run custom commands that don't include the host name since it's already set. However, I would like to get this working for future jobs to run.

New Member

Re: WLSE Device Specific Configurations

Could it be that you did not enter the dB or mW identifiers to the CSV file?

I found out that not only the levels must be specified but also these parameters.

Bas Kokken

106
Views
0
Helpful
3
Replies