I am running WLSE ver 2.5 with 1200 series access points, IOS ver 12.2(13)JA. I have the WLSE set to monitor associated clients and continue to recieve the fault AP is in Overloaded state (4294967295 associated clients. This only happens with a few AP's. I have compared configs with some of my other normally operating AP's and found nothing. I have been clearing the fault and rebooting the AP, this seems to solve it short-term. Any thoughts and ideas will be apreciated.
It's not a problem with WLSE itself, but a bug with the AP IOS->CSCec89492 which causes this as well as other problems in WLSE, including showing the associated clients in reports as negative. The bug also affects 13JA1. In WLSE you can disable these faults for now as a workaround.
< PRE >
(#)For this reason being that : - application that doesn't use multicast, sends one copy of each packet ( data unit of traffic at layer 3 ) to each client (" who seeks the traffic ).- application that does use multicast, sends ...
Transferring Crash file from standby:
Login to the Active WLC in HA.
(Cisco Controller) >transfer upload datatype crash
(Cisco Controller) >transfer upload filename <Desired filename>
(Cisco Controller) >transfer up...
This is the start of a display filter cross reference between Wireshark and OmniPeek.
The 1st installment is a table of advanced filters. More filters will be added as time allows.
It is a living doc, so check back for changes every so often
Please feel ...