Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

WLSE - how to delete unused IP segments

Is there any possibility how to delete unused segmentts from WLSE db?

More specific info(answer to subsidiary Cisco Expert Question below)

At 1st we had a WiFi locality - e.g. 10.1.97.0/29 is management seg. WLSE discover it.

Now we physically uninstall locality/HW but IP segment is still in WLSE db => WLSE generate still unaccessible/fault messages in periodic cycle.

It's incorrect by me. It is motivation to delete taht IP segm. from WLSE db.

Message was edited by: omrh

Everyone's tags (4)
3 REPLIES
Cisco Employee

Re: WLSE - how to delete unused IP segments

Can you ask the question a different way?  I'm not quite sure what you mean by unused IP segments in WLSE?

New Member

Re: WLSE - how to delete unused IP segments

My answer is upwards, I modified my original answer.

Cisco Employee

Re: WLSE - how to delete unused IP segments

You can go to Devices > Discover and search by IP address.  Use a wildcard for  IP range.  You will be presented with the devices that were in that range.  From there you can delete the decommissioned devices which should stop the fault messages.

759
Views
0
Helpful
3
Replies