WLSE it self is an Appliance based solution and is a Compliment of CW2K. You do not need CW2K in order to use WLSE but if you want to use it's functionality in addition to that of WLSE, that's would be a plus.
WLSE compliments CW2K. It has the following main features:
-Configuration and Firmware:
The configuration feature allows you to apply a set of configuration changes to access points and connected switch ports. Using the firmware feature, you can upgrade the firmware on access points and bridges.
Allows you to display reports for tracking device, client and security information. Reports can be emailed, printed, or exported.
- Fault and Policy Monitoring:
Provides device monitoring for fault and performance conditions, monitoring of LEAP server responses, and monitoring of policy misconfigurations.
These features are possible only with integration WLSE and CW2K? So it is the best way to manage public wlan with integration WLSE and CW2K, am I right? Does only monitoring for fault and performance conditions on LEAP servers (PEAP....)
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...