Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

wlse mail error: Data format error

I configured wlse (2.12) to send e-mail notifications to my address, but i don't received anyone and then i run "show maillog" and this is the result :

Dec 28 15:26:28 wlse sendmail[6444]: jBSFQSm06441: to=javalxxx@xxxx.es, ctladdr=casuser (200/200), delay=00:00:00, xdelay=00:00:00, mailer=relay, pri=31098, relay=smtp.xxxxxxx.es. [1xx.xxx.xxx.xxx], dsn=5.6.0, stat=Data format error

Where is the problem?

1 REPLY
Blue

Re: wlse mail error: Data format error

First make sure that you have defined your mail server correctly in WLSE config and is reachable. Then try sending a test mail from the CLI with the debug flag turned on to see where it fails. The syntax is mail to username@host DEBUG

200
Views
0
Helpful
1
Replies
CreatePlease login to create content