After upgrading, "Unable to verify MFP configuration","MFP Timebase Invalid (bad SNTP), Device was not reachable via SNMP" these messages are logging so many on WLSE fault status. What are these mean and How to solve this problems.
and "Client MAC Spoofing Detected on 004096ae4f8f , and on AP" this message also show up too many.What is this mean and what should i do clear this fault event log?
Transferring Crash file from standby: Login to the Active WLC in HA.
From CLI: (Cisco Controller) >transfer upload datatype crash (Cisco
Controller) >transfer upload filename (Cisco
Controller) >transfer upload mode tftp (Cisco Controller) >transfer
This is the start of a display filter cross reference between Wireshark
and OmniPeek. The 1st installment is a table of advanced filters. More
filters will be added as time allows. It is a living doc, so check back
for changes every so often Please feel f...
I have created a Powershell script to automatically add a Wireless Guest
User on Cisco WLCs. (tested on 2500 Series) The script should be
completely self explanatory. Prerequisites: Powershell SNMP Module
(Install-Module -Name SNMP) SNMP Write Access to y...